Installation How do you connect the throttle cable to the carburetor?
How do you connect the throttle cable to the carburetor?
1. Remove carb cap and lay out all the parts.
2. Place needle into center of carb slide and then put flat washer with groove on top of needle making sure you have the groove lined up with the groove in the carb slide.
3. Install cable to plastic grip first, then thread this end through the carb cap and through the spring.
4. Compress spring and load cable into the end of the slide. Once you have it started, put the entire length of the cable into the slide, once you have done that, release the spring to the inside of the carb slide allowing the spring to push onto the flat washer and thus holding the needle down.
5. Complete
6. Complete
Product Search
Login Form
Sponsored Links
Disclaimer
Operating motorized bicycles or bicycle engine kit involves some risk of bodily injury . Buyer accepts responsibility for any and all vehicle operation that may lead to personal injury, economic loss, social distress, other losses, costs and damages. EHBC Distributors Ltd is not responsible for injuries and/or damages resulting from operating this motorized bicycle or bicycle engine kit . Motorized bicycles are not recommended for use by persons under 16 years of age. Obey all traffic regulations. Always wear a helmet while riding. Never operate your motorized bicycle on a pedestrian through way or sidewalk while the engine is running. Never operate your motorized bicycle in an unsafe manner. Check local and state laws before riding on streets.