Example of Section Blog layout (FAQ section)

Where can I download a pull start or centrifugal clutch installation manual?

20 November 2008 Last Updated on 16 December 2008 administrator

We have prepared an installation manual for the pull start and centrifugal clutch addon kits.

Click on the link below to download the manual :

Addons Manual - Zoombicycles (0.5MB PDF File)

What type of frames will the engine mount on ?

31 July 2008 Ronald Moedt

The engine requires a clearance of at least 15 inches in height on the seat tube (the part of the frame under the seat) and 14-15 inches in length on the down tube (the diagonal part of the frame), and it is approximately 5 inches wide.

We recommend installing these kits on bicycles with a 1 inch diameter seat tube and with a 1-1.25 inch diameter on the down tube.

We have a gallery available on our website under www.zoombicycles.com and you will be able to view a selection of bicycles that these engines have been installed on.

The diagram below shows the spacing requirements for V-frame bicycles :

How do you connect the throttle cable to the carburetor?

21 May 2008 Last Updated on 21 May 2008 administrator

1. Remove carb cap and lay out all the parts.

2. Place needle into center of carb slide and then put flat washer with groove on top of needle making sure you have the groove lined up with the groove in the carb slide.

3. Install cable to plastic grip first, then thread this end through the carb cap and through the spring.

4. Compress spring and load cable into the end of the slide. Once you have it started, put the entire length of the cable into the slide, once you have done that, release the spring to the inside of the carb slide allowing the spring to push onto the flat washer and thus holding the needle down.

5. Complete

6. Complete

Where can I download a parts manual?

19 July 2008 Last Updated on 16 December 2008 administrator

We have prepared a parts manual for our bicycle engine kits.

Click on the link below to download the current you would like to view :

Parts Manual - Zoombicycles (15MB PDF File)

Parts Manual - Original (part numbers apply to eShop items)

Where can I download installation instructions?

24 April 2008 Last Updated on 16 December 2008 administrator

We have prepared two different sets of instructions for the bicycle engine kit installation.

Click on the links below to download the version you would like to view :

Installation Guide - Zoombicycles (5MB PDF File)

Installation Guide - Original (Included with all packages)

Installation Guide - Revised

Product Search

Login Form

Disclaimer

Operating motorized bicycles or bicycle engine kit involves some risk of bodily injury . Buyer accepts responsibility for any and all vehicle operation that may lead to personal injury, economic loss, social distress, other losses, costs and damages. EHBC Distributors Ltd is not responsible for injuries and/or damages resulting from operating this motorized bicycle or bicycle engine kit . Motorized bicycles are not recommended for use by persons under 16 years of age. Obey all traffic regulations. Always wear a helmet while riding. Never operate your motorized bicycle on a pedestrian through way or sidewalk while the engine is running. Never operate your motorized bicycle in an unsafe manner. Check local and state laws before riding on streets.