GasBikeShop Motorized Bicycle Conversion Engine Kits

1. Remove carb cap and lay out all the parts.

2. Place needle into center of carb slide and then put flat washer with groove on top of needle making sure you have the groove lined up with the groove in the carb slide.

3. Install cable to plastic grip first, then thread this end through the carb cap and through the spring.

4. Compress spring and load cable into the end of the slide. Once you have it started, put the entire length of the cable into the slide, once you have done that, release the spring to the inside of the carb slide allowing the spring to push onto the flat washer and thus holding the needle down.

5. Complete

6. Complete